MAGZIPSTRIP — SAMPLE QUALIFICATION WORKSHEET
Version: 2026-10-19 | inquiry@magzipstrip.com

Project / responsible approver:
Specimen ID and drawing revision:
A/B construction and material:
Carrier / enclosure / fabric stack:
Finished length, active length, width and total section:

For EACH evaluation, complete:
1. Question (normal pull / lateral retention / peel / cycling / care / exposure):
2. Applicable method and suitability for this assembly:
3. Specimen geometry, fixture, gap and restraint:
4. Direction, speed, temperature and other test conditions:
5. Conditioning procedure and number of cycles, if relevant:
6. Acceptance criteria agreed BEFORE testing:
7. Instrument / laboratory / test date:
8. Measured result, displacement and observed failure mode:
9. Before/after photographs and report reference:
10. Reviewer and release decision:

Keep load directions separate. Match every report to its sample and conditions.
Finished-product ratings and market approvals require their own applicable scope.
This is a blank planning tool, not a laboratory report or certification.